Build log · Phase 13, Hammock cranes

All 190 hammocks in line

19 September 2026 · Milestone

At last: all the hammocks are done. 190 of them, to be exact. Quite a job when you consider that each one takes me a good ten minutes. Well, they are all neatly in line now, and it does look rather good.

The method is the same as last year: the strip with seven pins in the vice, press the rolled hammock onto it, wind the rope round, fold it up and lay it in the netting. There is a short film of the process on the site. Fair warning: not narrated by me, if only I had a David Attenborough voice.

One hammock of the two hundred: strip of cloth, roll it, onto the batten with seven pins, seven turns of thread, finish under four turns, a drop of superglue. Recorded 11 September 2026, 2:27, 26 MB.
What is said

The Diana carries two hundred hammocks, rolled up in the nettings along the bulwark. This is one of them. I start with a strip of cloth, four by three centimetres. One edge of the strip was hemmed beforehand. That edge goes on the outside, so no frayed edge shows on the ship. I roll the cloth as tightly as I can, into a roll about as thick as a match. The batten in the vice has seven pins. I press the roll onto them, so it cannot move and the pins mark where the thread goes. Then the lashing, with fine thread. I start with two turns round the roll and pass the thread through them, so it forms a small knot that cannot slip. Then one turn between each pair of pins, pulling tight every time. Seven turns in all. On a real hammock that was the rule, one for each of the seven seas, or so the story goes. At the end, two turns again with the thread passed through. Then I take the roll off the pins and pass the needle under four of the turns, so it holds without a bulky knot. I cut the thread on both sides, and trim the ends once more, so it is neatly finished. A drop of superglue in the middle, so I can fold the hammock double without it springing open. And that is one. One hundred and ninety-nine to go.

The last hammock, rolled and bound on the cutting mat
The last hammock, rolled and bound on the cutting mat
Number 190 on the strip with the pins, the rope just wound round it
Number 190 on the strip with the pins, the rope just wound round it
Close up: the rolled hammock with the rope round it seven times
Close up: the rolled hammock with the rope round it seven times
The whole ship from above, the nettings full on both sides
The whole ship from above, the nettings full on both sides
The quarterdeck from above: the hammocks in the nettings along the bulwark
The quarterdeck from above: the hammocks in the nettings along the bulwark
The waist and half deck from the side, with the filled nettings above the guns
The waist and half deck from the side, with the filled nettings above the guns
The upper deck in line: 190 hammocks, all the same thickness
The upper deck in line: 190 hammocks, all the same thickness

In between, on 11 September, I did something else: I put the ship on a stool outside and took about a thousand photos all round it, and of every object separately. The only thing that matters is that the camera keeps the same zoom setting and the exposure is locked. A 3D model was made from them, which has been on the site since that day, with instructions for anyone who wants to try it.

And now? The hammock cranes are finished with this, and so is the upper deck. What the instructions ask for next is in the postscript to the previous post: first the deadeyes and chain plates under the channels, the holes in the bulwarks, the four boats, and only then the spars.